Automation Direct Do-more H2 PLC Series, Руководство пользователя по оборудованию

Страница: 181 / 242

Do-more H2 Series PLC User Manual, 1st Edition, Rev. F - H2-DM-M
7–15
Chapter 7: Specifications - Specialty Modules
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
H2-ECOM100 LED Indicators
H2-ECOM100 Network Identifiers
Each module must be assigned at least one unique identifier to make it possible for other devices
to recognize it on the network. There are four identifiers possible with the ECOM modules:
• Module ID
• Name
• IP (Internet Protocol) Address
• Ethernet (MAC) Address
The first three are user selectable but the MAC address is set at the factory. The type of identifier
chosen depends on the requirements of your particular application. PC-to-PLC communication
typically uses one type of identifier while PLC-to-PLC communication may require another. The
following table summarizes Network Identifiers and their uses:
H2-ECOM100 LED Descriptions
Indicator Status Description
STATUS
ON (Green) Module is powered up and functional
OFF Module powerup failed
LINKGD
ON (Green) Properly connected to network
OFF Not connected to network or incorrect configuration
ACTIVE
ON or FLASHING (Red) Active Network Data
OFF Network Idle
ERROR
ON or FLASHING (Red) A fatal error has occurred
OFF No error present
100MBIT
ON 100Base T Frequency detected
OFF (With ACTIVE LED ON) - 10Base T Frequency detected
STATUS
LINKGD
ACTIVE
ERROR
100MBIT
H2-ECOM100
10/100 BASE-T
ETHERNET PORT
10/100 BASE 10/100 BASE 0/ 00 S -TT -
ETHERNET PORT ETHERNET PORT HERNET PORT
Network Identifiers
Identifier How to Set Format Communication Notes
Module ID
DIP Switch Number 1–63 PLC-to-PLC or PC-to-PLC Disables Module ID in NetEdit3
NetEdit3 Number 1–90 PLC-to-PLC or PC-to-PLC DIP Switch must be set to “0”
NetEdit3 Number 1–999,999,999 PC-to-PLC only >90 (Not for PLC-to-PLC)
Name
NetEdit3 32 Alphanumeric Characters PC-to-PLC only HMI software may have restrictions
IP Address
NetEdit3
4 sets of numbers, up to three
digits each (192.168.76.3)
PC-to-PLC, (PLC-to-PLC
Client/Server using TCP/IP or
Modbus TCP protocols)
See your Network Administrator for
IP addresses
Ethernet (MAC) Address
Set at Factory 12 Hex digits PC-to-PLC only Factory assigned for IPX