Automation Direct Do-more H2 PLC Series, Руководство пользователя по оборудованию

Страница: 112 / 242

Do-more H2 Series PLC User Manual, 1st Edition, Rev. F - H2-DM-M
6–8
Chapter 6: Specifications - Analog I/O Modules
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
F2-04AD-1(L), Analog Input - continued
Setting the Module Jumpers
There are two channel selection jumpers, l1 and +2, that are used to select the number
of channels that will be used. See the figure below to find the jumpers on your module.
The module is set from the factory for four channel operation. Any unused channels are not
processed, so if you only select channels 1 thru 3, channel 4 will not be active. The following
table shows how to use the jumpers to select the number of channels. Unused jumpers can be
stored on a single post to prevent losing them.
F2-04AD-1(L) Module Jumper Table
Number of Channels Active Channels +1 +2
One Channel 1 No No
Two
Channels 1 and 2 Yes No
Three Channels 1, 2 and 3 No Yes
Four
Channels 1, 2, 3 and 4
Yes Yes
Yes = Jumper Installed No = Jumper Removed
+1 +2
Channel enable/disable jumpers
Jumper Location on Modules Having Date Code 0609F3
and Previous
(Two Circuit Board Design)
Jumper Location on Modules Having Date Code 0709G
and Above
(Single Circuit Board Design)
+1 +2
Channel enable/disable jumpers