Automation Direct Do-more H2 PLC Series, Руководство пользователя по оборудованию

Страница: 182 / 242

Do-more H2 Series PLC User Manual, 1st Edition, Rev. F - H2-DM-M
7–16
Chapter 7: Specifications - Specialty Modules
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
A Module ID is required for PLC-to-PLC communication and it can be set in two ways:
• Using the DIP switches on the module
• Using the configuration tools in
NetEdit3
• HTML configuration (after IP address is
assigned to module using NetEdit3)
Use the DIP switches if you want the
ability to install or change modules
without having to use a PC to set the
Module ID. Set the module’s DIP
switches, install the module in the base
and apply power. The Module ID will be
accepted on powerup and your ECOM
will be ready to communicate.
A Name makes it easy to recognize the PLC by its function. An example of a Name is
“PumpStationOne”, as seen in the diagram below. The Name can be up to 32 alphanumeric
characters in length.
NOTE: Some HMI software products will not accept Names with numbers as the first character, spaces or
certain other non-alphanumeric ASCII characters. Also, your HMI product may not accept Names longer
than 16 characters. Consult your HMI product documentation about its naming conventions.
An IP Address can be
assigned to the ECOM
module if your network
requires one. Usually, the IP
Address is required in cases
where PLCs are sharing the
same network with PCs, and
some of the PCs are carrying
out functions unrelated to
PLC control. Normally, a
network administrator will
assign an IP Address to each
device on the network. Use
NetEdit3 to configure the
assigned IP address to the
ECOM.
ON 7 6 5 4 3 2 1 0
2
5
2
4
2
3
2
2
2
1
2
0
(32) (16) (8) (4) (2) (1)
Not
Used
Binary Value
2 1 1 0 0 0 0
3
2
2
2
1
2
0
H2-DM1E
Pump Station One
ECOM
Module
Do-more
PLC
ERM
Module
AC
Drive
GS-EDRV100
One
Pump Station One
Module ID
Name
IP Address