Do-more H2 Series PLC Hardware User Manual, 1st Edition, Rev. F - H2-DM-M
1–29
Chapter 1: Getting Started
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Step 10: Testing Project Using Data View
With the project successfully downloaded into the Do-more PLC, you can now test
the function of the ladder program using the Data View tool. To start, you need
to open a new Data window in the software. To do so, click the Data icon in the
Project Toolbar, select Debug > Data View > New or press Ctrl+Shift+F3.
The Data View window seen here will now open. This
window will open in the project browser section of the
programming window but it can be relocated anywhere
on the screen by clicking the title bar and dragging it to
a new location.
Now enter the elements that you wish to monitor. On
line one type “C1” under the Element column and press
Enter. You will see the C1 change to the variable name
associated with it or T1_Start. On line two type the
element “C2” and on line three type “Y1”.
With the ladder elements entered into the Data View window, you now need to activate their
status. To do so, click the All Status icon on the Project Toolbar or select Debug > All Status
On. The All Status On option will not only activate the status of the Data View window but
also the status of the ladder program as seen on the following page.
The message seen here will appear asking you to
verify if this is a good time to do so. Since this is
the setup phase of this system, select Switch to
Program Mode and continue with the download.
If this system was previously commissioned
and in use, then you would need to verify that
the process it is controlling can be interrupted at this time
before continuing.
Download the project and once the download is finished,
assuming there are no errors, the Do-more PLC should
return to the Run mode. If at any time you
need to change the PLC mode, select the Mode
icon in the Project Toolbar, click the Mode
Status indication in the Status Bar or select
PLC > PLC Modes....
The PLC Modes window shown here will open displaying
the current mode the PLC is in with options to change it
to either Run or Program mode. Click OK to accept the
change or Cancel to exit.
Содержание Do-more H2 PLC Series
Страница 2: ...Notes...
Страница 6: ...Notes...
Страница 8: ...Notes...
Страница 231: ...Do more Product Weight Table A A A Appendix Appendix Appendix In This Appendix Do more Product Weight Table A 2...
