AE300-Wizard
Document No.:
E4.08.09
E4.08.09
:
AE_xx_000
Revision:
13
9
:
00
Page:
55 of 89
Copyright © 2019, Austro Engine GmbH
Dept.:
Electric/Electronic
Type:
User Guide
The Data Logger Window
The previous steps will cause the AE300-Wizard to import and interpret the selected data
logger hex dump file and to open a new window displaying the result (combining data from
both ECUs):
Time axis:
-
To left = towards past time
-
To right = towards present time
Navigation bar:
-
Zoom in/out signal axis
-
Zoom in/out time axis
Signal selection:
-
Move up/down signal axis
A menu to select any combination
-
Move left/right time axis
of ECU-A and -B signals for display
8.2.9.1
Saving Data Logger Displays as Screenshots
If just the current display of data logger data (as used in example 1 and 2) is to be saved,
the mechanisms built into MS Windows can be used as explained in chapter “6.6 Saving
Screenshots from Data Displays” on page 24.
8.2.9.2
Interpreting the Data Logger Display
When interpreting data logger displays the following facts should be observed:
1) If signals from both ECU-A and ECU-B are selected for the same display, i.e. to ana-
lyze relationships of ECU-A events to ECU-B events, the time difference between the
two real time clocks have to be taken into account. (e.g. if ECU-A RTC runs 10 sec-
onds ahead of ECU-B RTC as can be seen on the «Engine Data» tab’s RTC display,
the ECU-A events will be shifted by 10 seconds when compared to ECU-B events
even if they happened “at the same time” in real world).
2) Sample interval is 1 second, so any transients or fast changes in between those inter-
vals cannot be shown and the signals are interpolated from sample to sample.
3) To scan for flight cycles select “Barometric air pressure” and watch for the line to
drop below the 1000 hPa line.
4) To skip time, remember 1h = 3600 sec, 0.5 h = 1800 sec, 5 min = 300 sec, ….
Содержание AE300-Wizard
Страница 6: ......
