AudioCodes MediaPack MP-112, Руководство пользователя

Страница: 555 / 622

Version 6.6 555 MP-11x & MP-124
User's Manual 43. Configuration Parameters Reference
Parameter Description
numbers: 9 for dialing tone, 011 Country Code, and then any number
of digits for the local number ('x.').
Notes:

If the DialPlanIndex parameter is configured (to select a Dial Plan
index), then the device first attempts to locate a matching digit
pattern in the Dial Plan file, and if not found, then attempts to
locate a matching digit pattern in the Digit Map rules configured
by the DigitMapping parameter.

For more information on digit mapping, see 'Digit Mapping' on
page
241 .
Web: Max Digits in Phone
Num
EMS: Max Digits in Phone
Number
[MaxDigits]
Defines the maximum number of collected destination number digits
that can be received (i.e., dialed) from the Tel side. When the
number of collected digits reaches this maximum, the device uses
these digits for the called destination number.
The valid range is 1 to 49. The default value is 5.
Note s :

Instead of using this parameter, Digit Mapping rules can be
configured.

Dialing ends when any of the following scenarios occur:

Maximum number of digits is dialed

Interdigit Timeout (TimeBetweenDigits) expires

Pound (#) key is pressed

Digit map pattern is matched
Web: Inter Digit Timeout for
Overlap Dialing
[sec]
EMS: Interdigit Timeout (Sec)
[TimeBetweenDigits]
Defines the time (in seconds) that the device waits between digits
that are dialed by the user.
When this inter-digit timeout expires, the device uses the collected
digits to dial the called destination number.
The valid range is 1 to 10. The default value is 4.
Web: Enable Special Digits
EMS: Use '#' For Dial
Termination
[IsSpecialDigits]
Determines whether the asterisk (*) and pound (#) digits can be used
in DTMF.

[0] Disable = Use '*' or '#' to terminate number collection (refer to
the parameter UseDigitForSpecialDTMF). (Default.)

[1] Enable = Allows '*' and '#' for telephone numbers dialed by a
user or for the endpoint telephone number.
Note: These symbols can always be used as the first digit of a dialed
number even if you disable this parameter.