AudioCodes MediaPack MP-112, Руководство пользователя

Страница: 134 / 622

User's Manual 134 Document #: LTRT-65417
MP-11x & MP-124
Parameter Description
End Port
[AccessList_End_Port]
Defines the destination UDP/TCP end port (on this device) to where
packets are sent.
The valid range is 0 to 65535.
Note: When the protocol type isn't TCP or UDP, the entire range
must be provided.
Protocol
[AccessList_Protocol]
Defines the protocol type (e.g., UDP, TCP, ICMP, ESP or 'Any') or
the IANA protocol number in the range of 0 (Any) to 255.
Note: This field also accepts the abbreviated strings 'SIP' and
'HTTP'. Specifying these strings implies selection of the TCP or UDP
protocols, and the appropriate port numbers as defined on the
device.
Use Specific Interface
[AccessList_Use_Specific_I
nterface]
Determines whether you want to apply the rule to a specific network
interface defined in the Multiple Interface table (i.e., packets received
from that defined in the Source IP field and received on this network
interface):

[0] Disable (default)

[1] Enable
Notes:

If enabled, then in the 'Interface Name' field (described below),
select the interface to which the rule is applied.

If disabled, then the rule applies to all interfaces.
Interface Name
[AccessList_Interface_ID]
Defines the network interface to which you want to apply the rule.
This is applicable if you enabled the 'Use Specific Interface' field.
The list displays interface names as defined in the Multiple Interface
table in 'Configuring IP Network Interfaces' on page
105 .
Packet Size
[AccessList_Packet_Size]
Defines the maximum allowed packet size.
The valid range is 0 to 65535.
Note: When filtering fragmented IP packets, this field relates to the
overall (re-assembled) packet size, and not to the size of each
fragment.
Byte Rate
[AccessList_Byte_Rate]
Defines the expected traffic rate (bytes per second), i.e., the allowed
bandwidth for the specified protocol. In addition to this field, the
'Burst Bytes' field provides additional allowance such that momentary
bursts of data may utilize more than the defined byte rate, without
being interrupted.
For example, if 'Byte Rate' is set to 40000 and 'Burst Bytes' to
50000, then this implies the following: the allowed bandwidth is
40000 bytes/sec with extra allowance of 50000 bytes; if, for example,
the actual traffic rate is 45000 bytes/sec, then this allowance would
be consumed within 10 seconds, after which all traffic exceeding the
allocated 40000 bytes/sec is dropped. If the actual traffic rate then
slowed to 30000 bytes/sec, then the allowance would be replenished
within 5 seconds.
Burst Bytes
[AccessList_Byte_Burst]
Defines the tolerance of traffic rate limit (number of bytes).
The default is 0.
Action Upon Match
[AccessList_Allow_Type]
Defines the firewall action to be performed upon rule match.

"Allow" = (Default) Permits these packets

"Block" = Rejects these packets