AudioCodes MediaPack MP-112, Руководство пользователя

Страница: 529 / 622

Version 6.6 529 MP-11x & MP-124
User's Manual 43. Configuration Parameters Reference
Parameter Description
Manipulation Set parameter of the destination IP Group is not set.
Out-of-Service (Busy Out) Parameters
Web/EMS: Enable Busy
Out
[EnableBusyOut]
Enables the Busy Out feature.

[0] Disable (Default)

[1] Enable
When Busy Out is enabled and certain scenarios exist, the device does
the following:
The FXS port behaves according to the settings of the
FXSOOSBehavior parameter such as playing a reorder tone when the
phone is off-hooked, or changing the line polarity.
These behaviors are done upon one of the following scenarios:

The device is physically disconnected from the network (i.e.,
Ethernet cable is disconnected).

The Ethernet cable is connected, but the device is unable to
communicate with any host. For this scenario, the LAN Watch-Dog
must be activated (i.e., set the EnableLANWatchDog parameter to
1).

The device can't communicate with the proxy (according to the Proxy
Keep-Alive mechanism) and no other alternative route exists to send
the call.

The IP Connectivity mechanism is enabled (using the
AltRoutingTel2IPEnable parameter) and there is no connectivity to
any destination IP address.
Notes:

The FXSOOSBehavior parameter determines the behavior of the
FXS endpoints when a Busy Out or Graceful Lock occurs.

FXO endpoints during Busy Out and Lock are inactive.

See the LifeLineType parameter for complementary optional
behavior.
Web: Out-Of-Service
Behavior
EMS:FXS OOS Behavior
[FXSOOSBehavior]
Determines the behavior of undefined FXS endpoints and all FXS
endpoints when a Busy Out condition exists.

[0] None = Normal operation. No response is provided to undefined
endpoints. A dial tone is played to FXS endpoints when a Busy Out
condition exists.

[1] Reorder Tone = (Default) The device plays a reorder tone to the
connected phone/PBX.

[2] Polarity Reversal = The device reverses the polarity of the
endpoint marking it unusable (relevant, for example, for PBX DID
lines). This option can't be configured on-the-fly.

[3] Reorder Tone + Polarity Reversal = Same as 2 and 3 combined.
This option can't be configured on-the-fly.

[4] Current Disconnect = The device disconnects the current of the
FXS endpoint. This option can't be configured on-the-fly.
Note: This parameter is applicable only to FXS interfaces.
Retransmission Parameters
Web: SIP T1
Retransmission Timer
[msec]
EMS: T1 RTX
Defines the time interval (in msec) between the first transmission of a
SIP message and the first retransmission of the same message.
The default is 500.
Note: The time interval between subsequent retransmissions of the