AudioCodes MediaPack MP-112, Руководство пользователя

Страница: 469 / 622

Version 6.6 469 MP-11x & MP-124
User's Manual 43. Configuration Parameters Reference
Parameter Description
EMS: DNS Information
[SRV2IP]
names into DNS A-Records. Three different A-Records can be assigned
to a host name. Each A-Record contains the host name, priority, weight,
and port. The format of this parameter is as follows:
[SRV2IP]
FORMAT SRV2IP_Index = SRV2IP_InternalDomain,
SRV2IP_TransportType, SRV2IP_Dns1, SRV2IP_Priority1,
SRV2IP_Weight1, SRV2IP_Port1, SRV2IP_Dns2, SRV2IP_Priority2,
SRV2IP_Weight2, SRV2IP_Port2, SRV2IP_Dns3, SRV2IP_Priority3,
SRV2IP_Weight3, SRV2IP_Port3;
[\SRV2IP]
For example:
SRV2IP 0 =
SrvDomain,0,Dnsname1,1,1,500,Dnsname2,2,2,501,$$,0,0,0;
Note : For a detailed description of this table parameter, see 'Configuring
the Internal SRV Table' on page 123 .
43.1.8 DHCP Parameters
The Dynamic Host Control Protocol (DHCP) parameters are described in the table below.
Table 43-8: DHCP Parameters
Parameter Description
Web: Enable DHCP
EMS: DHCP Enable
[DHCPEnable]
Enables Dynamic Host Control Protocol (DHCP) functionality.

[0] Disable (default)

[1] Enable
After the device powers up, it attempts to communicate with a BootP
server. If a BootP server does not respond and DHCP is enabled,
then the device attempts to obtain its IP address and other
networking parameters from the DHCP server.
Notes:

For this parameter to take effect, a device reset is required.

After you enable the DHCP server, do the following:
a. Enable DHCP and save the configuration.
b. Perform a cold reset using the device's hardware reset button
(soft reset using the Web interface doesn't trigger the
BootP/DHCP procedure and this parameter reverts to
'Disable').

Throughout the DHCP procedure, the BootP/TFTP application
must be deactivated; otherwise the device receives a response
from the BootP server instead of from the DHCP server.

For more information on DHCP, refer to the Product Reference
Manual .

This parameter is a special 'Hidden' parameter. Once defined and
saved in flash memory, its assigned value doesn't revert to its
default even if the parameter doesn't appear in the
ini file.
EMS: DHCP Speed Factor
[DHCPSpeedFactor]
Defines the DHCP renewal speed.

[0] = Disable

[1] = (Default) Normal

[2] to [10] = Fast