AudioCodes Mediant 3000, Руководство пользователя

Страница: 784 / 872

User's Manual 784 Document #: LTRT-89729
Mediant 3000
Parameter Description
component on receipt of Facility IE with unknown/invalid
Invoke component. This bit is implemented in QSIG and ETSI
variants.
[PSTNExtendedParams]
Determines the bit map for special PSTN behavior parameters:

[0] = (Default) Applicable for NI-2 ISDN and QSIG "Networking
Extensions". This bit (i.e., bit #0) is responsible for the Invoke
ID size:

If this bit is not set (default), then the Invoke ID size is
always one byte, with a value of 01 to 7f.

If this bit is set, then the Invoke ID size is one or two bytes
according to the Invoke ID value.

[2] = Applicable to the ROSE format (according to the old
QSIG specifications). This bit (i.e., bit #1) is responsible for the
QSIG octet 3. According to the ECMA-165 new version, octet
3 in all QSIG supplementary services Facility messages
should be 0x9F = Networking Extensions. However, according
to the old version, the value should be 0x91 = ROSE:

If this bit is not set (default): 0x9F = Networking
Extensions.

If this bit is set: 0x91 = ROSE.

[3] = Use options [0] and [2] above.
Note: For this parameter to take effect, a device reset is required.
53.11.6.5 DS3 Parameters
The DS3 parameters are described in the table below.
Note: DS3 interface is applicable only to Mediant 3000 with TP-6310.
DS3 Parameters
Parameter Description
DS3 Settings Table
[DS3Config] This table parameter configures the DS3 (T3) interfaces. This
parameter has the following format:
[DS3CONFIG]
FORMAT DS3CONFIG_Index = DS3CONFIG_FramingMethod,
DS3CONFIG_ClockSource, DS3CONFIG_LineBuildOut,
DS3CONFIG_CircuitIdentifier, DS3CONFIG_TrapEnable,
DS3CONFIG_PmOnOff, DS3CONFIG_TappingEnable,
DS3CONFIG_AdminState;
[\DS3CONFIG ]
For example:
DS3CONFIG 0 = 0, 1, 2, , 1, 1, 0, 1;
Note: For a description of the parameters included in this table,
refer to their individual parameter descriptions below.