AudioCodes Mediant 3000, Руководство пользователя

Страница: 651 / 872

Version 6.6 651 Mediant 3000
User's Manual 53. Configuration Parameters Reference
Parameter Description
SrvDomain,0,Dnsname1,1,1,500,Dnsname2,2,2,501,$$,0,0,0;
Note : For a detailed description of this table parameter, see
'Configuring the Internal SRV Table' on page 134 .
53.1.8 DHCP Parameters
The Dynamic Host Control Protocol (DHCP) parameters are described in the table below.
DHCP Parameters
Parameter Description
Web: Enable DHCP
EMS: DHCP Enable
[DHCPEnable]
Enables Dynamic Host Control Protocol (DHCP) functionality.

[0] Disable (default)

[1] Enable
After the device powers up, it attempts to communicate with a BootP
server. If a BootP server does not respond and DHCP is enabled, then
the device attempts to obtain its IP address and other networking
parameters from the DHCP server.
Notes:

For this parameter to take effect, a device reset is required.

After you enable the DHCP server, do the following:
a. Enable DHCP and save the configuration.
b. Perform a cold reset using the device's hardware reset button
(soft reset using the Web interface doesn't trigger the
BootP/DHCP procedure and this parameter reverts to 'Disable').

Throughout the DHCP procedure, the BootP/TFTP application must
be deactivated; otherwise the device receives a response from the
BootP server instead of from the DHCP server.

This parameter is a special 'Hidden' parameter. Once defined and
saved in flash memory, its assigned value doesn't revert to its default
even if the parameter doesn't appear in the
ini file.
EMS: DHCP Speed
Factor
[DHCPSpeedFactor]
Defines the DHCP renewal speed.

[0] = Disable

[1] = (Default) Normal

[2] to [10] = Fast
When set to 0, the DHCP lease renewal is disabled. Otherwise, the
renewal time is divided by this factor. Some DHCP-enabled routers
perform better when set to 4.
Note: For this parameter to take effect, a device reset is required.