AudioCodes Mediant 3000, Руководство пользователя

Страница: 768 / 872

User's Manual 768 Document #: LTRT-89729
Mediant 3000
Parameter Description
[ISDNDMSTimerT310] Defines the override T310 timer for the DMS-100 ISDN variant.
T310 defines the timeout between the receipt of a Proceeding
message and the receipt of an Alerting/Connect message.
The valid range is 10 to 30. The default is 10 (seconds).
Notes:

Instead of configuring this parameter, it is recommended to
use the parameter ISDNTimerT310.

This parameter is applicable only to Nortel DMS and Nortel
MERIDIAN PRI variants (ProtocolType = 14 and 35).
[ISDNTimerT301] Defines the override T301 timer (in seconds). The T301 timer is
started when a Q.931 Alert message is received. The timer is
stopped when a Q.931 Connect/Disconnect message is received
from the other side. If no Connect or Disconnect message is
received within the duration of T301, the call is cleared.
The valid range is 0 to 2400. The default is 0 (i.e., the default
T301 timer value - 180 seconds - is used). If set to any other
value than 0, it overrides the timer with this value.
Notes:

For this parameter to take effect, a device reset is required.

This parameter is applicable only to the QSIG variant.
[ISDNJapanNTTTimerT3JA] Defines the T3_JA timer (in seconds). This parameter overrides
the internal PSTN T301 timeout on the Users Side (TE side).
If an outgoing call from the device to ISDN is not answered during
this timeout, the call is released.
The valid range is 10 to 240. The default is 50.
Notes:

This timer is also affected by the parameter
PSTNAlertTimeout.

This parameter is applicable only to the Japan NTT PRI
variant (ProtocolType = 16).
Web/EMS: Trace Level
[TraceLevel]
Defines the trace level:

[0] No Trace (default)

[1] Full ISDN Trace

[2] Layer 3 ISDN Trace

[3] Only ISDN Q.931 Messages Trace

[4] Layer 3 ISDN No Duplication Trace
Web/EMS: Framing Method
[FramingMethod]
Determines the physical framing method for the trunk.

[0] Extended Super Frame = (Default) Depends on protocol
type:

E1: E1 CRC4 MultiFrame Format extended G.706B (same
as c)

T1: T1 Extended Super Frame with CRC6 (same as D)

[1] Super Frame = T1 SuperFrame Format (as B).

[a] E1 FRAMING DDF = E1 DoubleFrame Format - CRC4 is
forced to off

[b] E1 FRAMING MFF CRC4 = E1 CRC4 MultiFrame Format -
CRC4 is always on

[c] E1 FRAMING MFF CRC4 EXT = E1 CRC4 MultiFrame
Format extended G.706B - auto negotiation is on. If the
negotiation fails, it changes automatically to CRC4 off (ddf)