AudioCodes Mediant 3000, Руководство пользователя

Страница: 702 / 872

User's Manual 702 Document #: LTRT-89729
Mediant 3000
Parameter Description
law/
µ
-law with adaptations (see the Note below).
Notes:

Fax adaptations (for options 2 and 3):

Echo Canceller = On

Silence Compression = Off

Echo Canceller Non-Linear Processor Mode = Off

Dynamic Jitter Buffer Minimum Delay = 40

Dynamic Jitter Buffer Optimization Factor = 13

If the device initiates a fax session using G.711 (option 2 and
possibly 3), a 'gpmd' attribute is added to the SDP in the following
format:

For A-law: 'a=gpmd:8 vbd=yes;ecan=on'

For
µ
-law: 'a=gpmd:0 vbd=yes;ecan=on'

When this parameter is set to 1, 2, or 3, the parameter
FaxTransportMode is ignored.

When this parameter is set to 0, T.38 might still be used without the
control protocol's involvement. To completely disable T.38, set
FaxTransportMode to a value other than 1.

This parameter can also be configured per IP Profile (using the
IPProfile parameter).

For more information on fax transport methods, see 'Fax/Modem
Transport Modes' on page
169 .
[HandleG711asVBD] Enables the handling of G.711 as G.711 VBD coder.

[0] = (Default) Disable. The device negotiates G.711 as a regular
audio coder and sends an answer only with G.729 coder. For
example, if the device is configured with G.729 and G.711 VBD
coders and it receives an INVITE with an SDP offer containing G.729
and “regular” G.711 coders, it sends an SDP answer containing only
the G.729 coder.

[1] = Enable. The device assumes that the G.711 coder received in
the INVITE SDP offer is a VBD coder. For example, if the device is
configured with G.729 and G.711 VBD coders and it receives an
INVITE with an SDP offer containing G.729 and “regular” G.711
coders, it sends an SDP answer containing G.729 and G.711 VBD
coders, allowing a subsequent bypass (passthrough) session if
fax/modem signals are detected during the call.
Note: This parameter is applicable only if G.711 VBD coder(s) with
regular G.711 payload types 0 or 8 are configured for the device (using
the CodersGroup parameter).
[FaxVBDBehavior]
Determines the device's fax transport behavior when G.711 VBD coder
is negotiated at call start.

[0] = (Default) If the device is configured with a VBD coder (see the
CodersGroup parameter) and is negotiated OK at call start, then
both fax and modem signals are sent over RTP using the bypass
payload type (and no mid-call VBD or T.38 Re-INVITEs occur).

[1] = If the IsFaxUsed parameter is set to 1, the channel opens with
the FaxTransportMode parameter set to 1 (relay). This is required to
detect mid-call fax tones and to send T.38 Re-INVITE messages
upon fax detection. If the remote party supports T.38, the fax is
relayed over T.38.
Notes:

If VBD coder negotiation fails at call start and if the IsFaxUsed
parameter is set to 1 (or 3), then the channel opens with the