AudioCodes Mediant 3000, Руководство пользователя

Страница: 619 / 872

Version 6.6 619 Mediant 3000
User's Manual 49. Syslog and Debug Recordings
Parameter Description
SBC application).

[12] User = Filters according to a specified user defined by username or
user@host.

[13] IP Trace = Filters according to a specified IP network trace
wireshark-like expression. For a detailed description on configuring IP
traces, see 'Filtering IP Network Traces' on page
619 .
Value
CLI: value
[LoggingFilters_Val
ue]
Defines the value of the selected filtering type in the 'Filter Type' parameter.
The value can be the following:

A single value

A range, using a hyphen "-" between the two values, e.g., "1-3"

Multiple, non-contiguous values, using commas "," between each value,
e.g., "1,3,9"

Trunks pertaining to a module, using the syntax module number/port or
port, for example:

"1/2", means module 1, port 2

"1/[2-4]", means module 1, ports 2 through 4

Any to indicate all

For IP trace expressions, see e 'Filtering IP Network Traces' on page
619
Syslog
[LoggingFilters_Sy
slog]
Enables Syslog messages for the defined logging filter:

[0] Disable (default)

[1] Enable
Capture Type
[LoggingFilters_Ca
ptureType]
Enables debug recordings for the defined logging filter and defines what to
record:

[0] None (default)

[1] Signaling = Information related to signaling such as SIP signaling
messages, Syslog, and CDR.

[2] Signaling & Media = Signaling and media (RTP/RTCP/T.38).

[3] Signaling & Media & PCM = Signaling, media, and PCM (voice
signals from and to TDM).

[4] PSTN trace = ISDN and CAS traces - applicable only for Trunk-
related filters.
49.4.1 Filtering IP Network Traces
You can filter Syslog and debug recording messages for IP network traces, by setting the
'Filter Type' parameter to
IP Trace in the Logging Filters table. IP traces are used to record
any IP stream that is not associated with media (RTP/RTCP), according to destination
and/or source IP address, or port and Layer-4 protocol (UDP, TCP or any other IP type as
defined by
http://www.iana.com ).
When the IP Trace option is selected, only the ‘Value’ parameter is applicable; the 'Syslog'
and 'Capture Type' parameters are not relevant. The 'Value' parameter configures the
Wireshark-like filtering expressions for your IP trace. The following Wireshark-like
expressions are supported: