Assa Abloy TRAKA32, Руководство пользователя

Страница: 442 / 919

V3.5 14/08/19 UD0089 Page 442
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
The other report shows you only the Outstanding Faults that have yet to been seen to. To view the reports of the
Immobilisors that have only outstanding faults logged against them go to the top left corner of Traka32 and click
Reports > Crystal Reports > Faults > iFob Per Person Outstanding Faults.
The Report will look as pictured below and is very similar to the Fault History report however this report only shows
Outstanding Faults that have not been cleared or repaired. You can print off both versions of the reports if desired.
NOTE: A fault that has been repaired will remain on the outstanding fault list report until it has been
cleared.
Resetting the Immobilisor
After you have cleared the fault from the Traka32 software the Immobilisor itself needs to be reset using a Service
iFob. Service iFobs are usually Grey however with iFob Per Person systems we use Green Service iFobs. If you haven't
done so already, you need to make sure your Service iFob has 'Permit Clear Fault at Vehicle' option enabled in order to
reset and clear all the faults recorded at the Immobilisor. By default 'Permit Start Vehicle' & 'Permit Diagnostics' are
automatically ticked and greyed out when the 'Permit Clear Fault at Vehicle' option is selected.