Assa Abloy TRAKA32, Руководство пользователя

Страница: 690 / 919

V3.5 14/08/19 UD0089 Page 690
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
3.20.10.3.2 CHANGING 16BIT CONTROL HARDWARE
When changing the 16bit Control hardware, the replacement hardware must be re-configured for the new system.
Because the 16bit application firmware is generic and not customer specific (like the 8bit firmware), a configuration file
is required to customise the firmware for each system. The configuration file contains the configurable parts to the
system such as the number of receptor strips and card reader settings as well as the cost
options .
Without a configuration file, a Traka System can be used as normal, however no cost options will be enabled and the
card reader settings will remain as they were last programmed into the Control PCB.
The communications between Traka32 and the Traka System will also be possible for up to 30 days, but every time
communications is initiated, Traka32 will prompt for a configuration file first.
When changing the 16bit Hardware
1. After changing the hardware and communicating for the first time, the 16bit Configuration Wizard will be
displayed.
2. Click on Next.
3. The CPSN window is displayed confirming the Serial Number, CPSN Read from Hardware, the Hardware and
Code versions and in addition the Traka32 version the firmware was tested with.