1-800-810-WIRE • www.sargentlock.com • A8185A 22
Copyright © 2016, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
04/30/16
IN120 Exit Device
A. Connect motor harness adapter to chassis harness connector (Fig. 4).
B. For wood doors: Route ET wire harness connector through the cylinder hole,
up and through the wire run channel to the controller cutout.
For metal doors: Route ET wire harness through the cylinder hole out the
controller cutout.
C. Pass top ET trim mounting post through chassis harness ground lug.
D. Ensure ET spindle engages the lower hub of the exit chassis.
E. Begin to secure chassis to ET trim by partially tightening (2) chassis through
bolts (Fig. 4B).
Do not fully tighten at this time.
A
B
C
D
NOTE: Cable lengths exaggerated for illustrative purposes.
E
4 Position Exit Trim (ET)
Fig. 4A
Outside of Door
Inside of Door
Partially
Tighten
Fig. 4B
NOTE: For exterior applications, use ET gasket (52-0263) as a seal between
ET escutcheon and outside door surface.