04/30/16
9 1-800-810-WIRE • www.sargentlock.com • A8185A
Copyright © 2016, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
IN120 Exit Device
3 Mount Exit Device Chassis
NOTE: Exit chassis harness consists of a 6-pin female connector and two
different-sized ground lugs (Fig. 3A)
1. Feed 6-pin connector and
larger
ground lug straight through to outside of
door (Fig. 3A, B) while feeding smaller ground lug into wire hole, up through
wire channel and out through inside of door (Fig. 3C).
DO NOT PINCH THE WIRE HARNESS.
2. Begin to secure the exit chassis with through bolts
to the ET trim using (2) 1/4 -20 x 2-3/8”
flat head machine screws.
Do not fully tighten at this time.
Inside of Door
(2) 1/4 x 2-3/8”
Flathead Machine
Screws (secures ET)
Exit Chassis
Fig. 3A
Fig. 3B
Outside of
Door
Inside of Door
Fig. 3C
