1-800-810-WIRE • www.sargentlock.com • A8185A 28
Copyright © 2016, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
04/30/16
IN120 Exit Device
1. Insert top tabs of controller into slots on mounting plate (Fig. 10).
2. Ensure proper alignment of board-to-board connectors while pivoting bottom
of controller toward door until tab on bottom snaps securely into place on
mounting plate.
CAUTION
: To avoid possible damage to board-to-board connectors,
care should be taken when securing controller to mounting
plate. If there is resistance when securing, detach controller
to determine cause before re-attaching controller.
10 Install Inside Module Component Assembly
Fig. 10