Ｃｈａｐｔｅｒ ＩＶ Ｌｏｃａｌ Ｏｐｅｒａｔｉｏｎ
76
ARRAY
Step 2:
Select “L_Level” via
key or
and
keys; enter the transient low level
1 by the number keypad, or via knob with
and
keys; then press
key to
confirm;
Step 3:
Select “H_Level” via
key or
and
keys; enter the transient high level
5 by the number keypad, or via knob with
and
keys; then press
key to
confirm;
Step 4:
Select “LowTime” via
key or
and
keys; enter the low level time
0.00100 by the number keypad, or via knob with
and
keys; then press
key to
confirm;
Step 5:
Select “HighTime” via
key or
and
keys; enter the high level time
0.00100 by the number keypad, or via knob with
and
keys; then press
key to
confirm;
Step 6:
Select “RiseTime” via
key or
and
keys; enter the time for rising
edge 0.00001 by the number keypad, or via knob with
and
keys; then press
key to confirm;
Step 7:
Select “FallTime” via
key or
and
keys; enter the time for falling
edge 0.00001 by the number keypad, or via knob with
and
keys; then press
key to confirm;
Step 8:
Select “Mode” via
key or
and
keys; select
Pulse
via knob or
dynamic
keys; then press
key to confirm;
Step 9:
Press
key to open the load;
Step 10:
Send the load the trigger initial command: INIT or INIT
：
CONT;
Step 11:
The signal at the trigger terminal (TRIG IN) is low and the load executes one trigger.
The corresponding SCPI commands of the above procedures should be as follows:
Содержание 3750A
