ARC FLEX 2JB-VRX, Инструкция по эксплуатации

Страница: 18 / 71

Flex 2JB-VRX Instruction Manual
June 2022 v1.0
Page 17 of 70
4.1.2 Transmitter Channel Programming
A. Unassigned Channel Scheme (no preset system channel)
When both transmitter and receiver is set to unassigned channel scheme (no
preset channel), the system automatically search and lock onto a free and
uninterrupted channel at every transmitter startup. Tandem, random access and
pitch & catch configurations “cannot” set to unassigned channel scheme.
1) Reset the STOP button (Status LED turned green for up to 2.0 seconds, transmitter
power on).
2) Press and hold both PB5 and PB6 at the same time for up
to 3.0 seconds (Staus LED blinks orange). Let go of both
PB5 and PB6 when LED-A and LED-B turned red.
3) Entered programming mode with Status LED displays 1x
orange blink for firmware version, remote pairing and IR
programming.
2x orange blinks for transmitter channel
programming , 3x orange blinks for PB1~PB7 function
programming, 4x orange blinks for frequency
range indication, 5x orange blinks for TAC programming.
4) Select transmitter channel programming mode (Status LED 2x orange blinks) by
press and hold PB6 for up to 3.0 seconds (LED-B turned red). Let go PB6 when
Status LED turns to 2x orange blinks.
5) Enter transmitter channel programming mode by press and hold both PB5 and
PB6 at the same time for up to 3.0 seconds (LED-A and LED-B turned red). Let
go of both PB5 and PB6 when Status LED dispays the current transmitter channel
setting. A green blink represents the tens (+10), a red blink represents the units
(+1) and constant orange represents unassigned channel. For example, 1x green
blink followed by 5x red blinks is channel 15.
6) Change transmitter channel to “unassigned channel” by press and hold both PB5
and PB6 at the same time (Status LED displays constant orange for unassigned
channel). Make sure constant orange is shown on the Status LED before
proceeding to the next step.
7) Transfer the unassigned channel setting to the receiver by pressing the green
START button until the Status LED turns to constant green (transfer complete).
Turn off the transmitter power if constant green is not shown on the Status LED
after more than 5.0 seconds (transfer incomplete); the transmitter will revert back
to its previous channel setting. Make sure the receiver power is turned on and
within the operating distance during the entire process. When transmitter is set to
“ unassigned channel ” , the receiver must also set to “ unassigned channel ” in
order for the entire system to work.
8) Exit transmitter channel programming mode by pressing down the STOP button
(transmitter power off).
PB5
PB6