AP ARTON-08F, Руководство по эксплуатации

Страница: 22 / 38

2 3
8.6 Section 3. Configuration of « 1» .. « 4» outputs
Table 8.3
Section
Output
number
n
Code and name
of parameter
Parameter’s
value
Description
Setting of Kn output mode
11
disabled – passive state, enabled – active state
(
by default )
12 Enabled – passive state, disabled – active state
13
Disabled – passive state, pulsing mode – active state
14 Enabled – passive state, pulsing mode in active state
3 n 2
15
Enabled – passive state, pulsing mode in active state
if one of AL involved to activation condition is
disabled by an authorized user.
Setting of Kn output activation time
11
1 sec.
12 5 sec.
13
10 sec.
14 30 sec.
21
1 min.
22 3 min.
23
10 min.
24 30 min.
31
1 h
32 3 h
33 10 h
3 n 3
34
Not limited (till resetting of activation condition)
(
by default )
3
n
4
Output’s activation condition
(see Note 8.5.1 in the previous section)
3
n
5
Mask of loops involved to activation condition of the output,
(see Note 8.6.1)
Type of load control of Kn output
11 Control only “S/C” ( by default ).
12
Control only “O/C” (1-10 kOhm resistor is required
to be installed parallel to load)
13 Control «S/C» and «O/C».
3 n 6
14 No control.
Time of transition processes at Kn switching
11
150 msec ( by default )
12 200 msec
13
250 msec
3 n 7
14 300 msec
Frequency of output’s pulsing mode
11 0,5 Hz 3 n 8
12 1 Hz ( by default )
Note 8.6.1
AL mask determines the AL involved to «Kn» activation condition.
From 1 to 8 alarm loops with AND/OR operation logics can be involved to activation condition of
each output. When programming the parameter one of red LED displays the output’s number, and [1]..[8]
yellow indicators light indicates the loops involved to activation condition of the output. Thus the steady
light of yellow zone indicator means the zone going to activation condition by AND , and flashing of zone
yellow indicator means entering the activation condition of the output by OR .