AMX NetLinx NXP-TPI/4, Руководство по эксплуатации/справочник

Страница: 16 / 148

Installation
10 NXP-TPI/4 NetLinx Touch Panel Interface
Step 1: Removing Input Card Covers
1.
Detach all connectors from the TPI/4 unit.
2.
Discharge any static electricity from your body by touching a grounded metal object or the
grounding bolt shown in FIG. 4.
3.
Carefully remove each card by unscrewing both the two flat-head (top of each cover) and round
Phillips-head screws (rear of each cover) as shown in FIG. 5.
4.
Securely grasp the input card cover.
5.
Remove the screws from the input card cover and repeat this removal process for each cover.
6.
Once the screws are removed, pull the cards upwards and away from the main TPI/4 unit.
Step 2: Removing the Outer TPI/4 Housing
1.
Detach all connectors from the TPI/4 unit.
2.
Verify the removal of all input card covers from the housing.
3. Carefully remove the housing by unscrewing the four flat Phillips-head screws from both sides of
the TPI/4 outer housing (2 per side as seen in FIG. 5 and FIG. 6) and the three flat
Phillips-head screws from along the rear-underside of the unit.
4.
Unscrew the two connector bolts (four total) from either side of the rear TOUCH INPUT and VGA
OUTPUT connectors.
5.
Carefully unscrew the grounding bolt from the rear of the TPI/4 unit.
6.
Carefully remove the outer housing by gently sliding the top housing away from the front of the
unit. The removal allows you to view the internal memory located on the main board (FIG. 6).
Always power-down the unit before attempting to remove or install input modules.
Failure to do so could result in damage to the TPI/4 and input cards.
Do not to allow the card covers to fall through the housing and onto the circuit board
during the removal process.
FIG. 5 Removing input card covers
Blank card covers
Outer housing
Housing screws
Flat-head screws
Round screws