AMX NetLinx NXP-TPI/4, Руководство по эксплуатации/справочник

Страница: 10 / 148

Product Information
4 NXP-TPI/4 NetLinx Touch Panel Interface
Specifications (Cont.)
Button Assignments: Button assignments can only be adjusted in TPD4 and not on the TPI/4s.
• Button channel range: 1 - 4000 button push and feedback (per address port)
• Button variable text range: 1 - 4000 (per address port)
• Button states range: 1 - 256 (General Button; 1 = Off State, 2 = On State)
• Level range: 1 - 600 (Default level value 0-255, can be set up to 1-65535)
• Address port range: 1 - 100
Front Components:
PWR LED
• Green LED indicates power status.
Serial port
• DB9 connector (male) is used for connection to a DB9 serial port on a PC
( used for serial communication ).
ICSP LED
• Green LED indicates ICSNet communication is detected.
Input LEDs (1 - 4)
• 4 yellow LEDs indicates a valid input signal on a respective card slot.
Pushbuttons
Four white pushbuttons located on the front of the interface give access to:
• RESOLUTION: Opens a screen used to select the TPI/4 output video signal
resolution, ranging from 600 x 800@60Hz to 1280 x 1024@60Hz. This
output resolution can’t be greater than the resolution on the connected panel.
Refer to the Step 1: Setting the Output Resolution on the TPI/4 section on
page 28 for more information.
• TOUCH: Opens the Protected Setup page where you can select (from a
series of touch panel drivers - page 3) and set the driver that corresponds to
the panel connected to the TOUCH INPUT connector on the rear of the
TPI/4 unit. Refer to the
Step 2: Setting the Touch Drivers section on page 29
for more information.
• CALIBRATE: Opens a panel page displaying a series of crosshairs. These
crosshairs are used to calibrate the touch device being used. Refer to the
Step 3: Calibrating the TPI/4 section on page 31 for more information.
• SETUP: Opens the TPI/4 firmware setup menu. Refer to the Firmware Pages
and Descriptions section on page 55 for more information.
Rear Components:
Card Slots: • Equipped with any combination of input modules (TP4-VID S-Video/
Composite or TP4-RGB VGA Input module).
Outputs: • VGA (HD-15 VGA Output Port of TPI/4) and RGB (HD-15 port on TP4-RGB)
Input Card Slots
Any combination of four TPI/4 input cards:
• TP4-RGB Card: HD-15 D-Sub and USB host port for computer control
(through either a mouse or keyboard).
• TP4-VID Video Card: Switchable Composite and S-Video input.
• Refer to the TP4 Input Cards section for more detailed information on these
cards.
Note: Input slots are universal. You can use any combination of input modules
in any of the four input slots. The NXP-TPI/4 handles multiple input resolutions
and refresh rates.
Touch Input port:
• RS-232 (DB9) 9-pin serial port. Used to connect a pointer device such as a
touch screen.