AMX Modero NXA-WAP200G, Инструкция по эксплуатации

Страница: 47 / 82

Wireless Device Communication Setup
41
NXA-WAP200G Wireless Access Point
Logging into the WAP200G within Bridge Mode
The default Mode setting for the WAP200G is Access Point (AP).
1.
Follow the procedures outlined in the Configuring the Communication section on page 21 to
establish the communication parameters between the computer and the target WAP200G.
2.
Use the information from the Logging into the WAP200G within Access Point Mode section on
page 27 to communicate to the WAP200G through a web browser configured for TCP/IP
Networking.
3.
Press the Administration tab from the bottom row of the Configuration Utility to open the
Administration page.
4.
From the Commands section of the page, press the on-screen Bridge button to place the
WAP200G into the Bridge Mode. When placed in this mode the WAP200G allows devices
with only wired 10/100 Ethernet ports such as; printers, PlayStation2s, X-Boxes, PVRs, etc. to
connect wirelessly to the network.
5.
Click OK (from the confirmation dialog) to reconfirm you want to reboot the WAP200G. A
new Temporarily Saved page appears and instructs you to wait a few seconds for the unit to
make the necessary changes.
6.
Slide the rear AP/BRIDGE switch (on back of the WAP200G) to BRIDGE .
7.
Cycle power to the unit before continuing with the setup procedures.
8.
Manually cycle power to the WAP200G by disconnecting and re-connecting the power
connector from the rear power port on the WAP200G.
9.
Open a TCP/IP network configured web browser.
10.
Verify the computer and the WAP200G are on the same LAN, within the same IP Address
pool. If you are having trouble communicating with your WAP200G, refer to the
Troubleshooting section on page 71.
11.
Type http://192.168.1.240/ (default WAP200G IP Address) into the web browser’s Address
field (or the URL field) at the top of the browser window. This is the same location where you
type in the resolvable web address such as http://www.amx.com. 192.168.1.240 is the default
IP Address of the NXA-WAP200G Wireless Access Point.
12.
Press the Enter key.
13.
Once you hit the Enter key, the Login window (FIG. 35) will appear and you will need to enter
the following default information:
User Name : Admin (Case Sensitive)
Password : 1988
14.
Click OK to enter the information and access the browser-based configuration screens.
Once the WAP200G is setup with the Static IP Address and the source computer has
been restored with Internet communication; the web browser can then be used to
access the Static IP Address of the WAP200G (using the correct username and
password) and configure the Configuration Utility parameters such as IP Address,
and Security options