AMX Epica DGX 32, Инструкция по эксплуатации

Страница: 140 / 147

Appendix D – Programmer’s Interface for System Diagnostics
134 Epica DGX 32 Instruction Manual
Verbosity Settings
The verbosity (
v
) settings (
v0
,
v1
,
v2
,
v3
) correspond to the level of detail that will be displayed,
with v0 being the lowest level of detail and v3 being the highest level.
Component Identity Settings
Detailed information for a single system component can be specified by using its identity (
i
) number
setting (
i1
through
i7
) in the following table. Minimal information for all seven components an be
specified by using the identity number
i0
.
Default Settings
At system boot, the ~ scrv0i1 setting is displayed (FIG. 20 on page 37).
If the verbosity setting is omitted, the verbosity level will be the lowest (
v0
).
The component setting must be included; otherwise, entering any of the verbosity settings
alone will result in a display equivalent to
v0i0
.
If both settings are omitted during a query ( ~scr! ), the information displayed will be at the
lowest verbosity level for all components (
v0i0
) (FIG. 42 on page 133).
Using BCS to Access System Diagnostic Information
Instructions are provided for accessing the lowest level of verbosity for all components and for accessing
a specific level of verbosity for a specific component.
To access the lowest level of verbosity for all components:
1.
Enter ~scr! or ~scrv0i0!
Note: Either of these commands provides a “menu” of the identity numbers and their corresponding
components (FIG. 42 on page 133).
Only one verbosity setting and one component setting can be entered in a command. The order in which
the verbosity and component settings are entered is interchangeable.
To access a specific level of verbosity for a specific component:
1. Enter
~scr
(to access the splash screen).
2. Enter the verbosity level setting
v#
and the component identity setting
i#
.
Either may be specified first.
3.
Enter ! (to send the command).
Example
~scrv3i6! or ~scri6v3! (Either displays the highest level of detail for the Power System.)
Component Identity Number
All Components
i0
Enclosure
i1
Storage Blocks
i2
Communication Interfaces
i3
Hardware / Boards
i4
VM Configuration
i5
Power System
i6
System Sensors
i7