AMX Epica DGX 144, Инструкция по эксплуатации

Страница: 61 / 107

Epica DGX 144 HD-15 RGBHV Input Board
57 Epica DGX 144 Instruction Manual
11.
Adjust the rest of the icons if needed, keeping the following tips in mind:
Horizontal Position
If not working, try adjusting Horizontal Pulse Width first and then retry Horizontal
Position.
CRT screens may need to use the screen controls to fine tune for size and position.
Vertical Position
CRT screens will often go blank for a moment on each adjustment.
To quickly make large adjustments to CRT screens, use the Page Up / Page Down keys.
Horizontal Pulse Width
The default normally works well for higher resolutions.
For lower resolutions that do not fit the display well, try increasing the value.
Reduced blanking resolutions (>1600x1200) require a small value.
Phase Timing
If you try to adjust this setting and do not see a difference, adjustment is not necessary.
If adjustment is needed, open the file PhaseTest.pdf.
Watch the image and adjust to even out any picture variation.
12. Repeat as many of the steps above as necessary for additional sources (see Time Saving Tip below).
13.
From the Options menu, select Save to System (to restore settings upon power up).
The Save to System Dialog box opens.
14.
Click OK.
15. From the File menu, select Save As to save a backup file to the PC.
16.
Enter a file name, and click Save.
17.
Disconnect the Control PC when finished.
Time Saving Tip: If additional source devices of the same type are connected to the same type of
destination devices, the setting for the file saved in Step 14 can be applied to those sources. Use the
following directions.
To apply settings to multiple sources:
1.
From the Options Menu, select Enable Multiple Selections.
2.
Select (highlight) the label for the source whose settings need to be duplicated.
3.
Click the check boxes for all sources that require the same settings as the selected source.
4. From the Options Menu, select the submenu Copy to Selected \ Current Profile.
The settings from the highlighted source are applied to all sources that were selected in Step 3.
FIG. 30
Select source to copy settings from; check source(s) to apply settings to