Installation and Setup
40
Epica DGX 144 Instruction Manual
APWeb
For startup information, see the APWeb Server Module’s documentation.
HyperTerminal
When power is applied to the enclosure, HyperTerminal displays a one-line splash screen followed by
“
Ready
” (FIG. 21). The system is ready to disconnect the factory default switch and to execute a test
switch (see page 41). If you need to access advanced system information* through HyperTerminal, see
“Appendix D – Programmer’s Interface for System Diagnostics” on page 93.
Note:
AMX reserves the right to add to the contents of the splash screen at any time, without notice.
* Advanced system information is also available through APDiagnostics software (see page 79).
Redundant Power Supply (RPS)
Each enclosure ships with up to four mutually-redundant (hot-swappable) power supplies.
Depending on how many power supplies are in the system and the load of the system, the RPS indicator
on the front of the enclosure may blink (red or green) if a problem occurs. Check the AC and DC LED
indicators on the rear of the enclosure directly above each power receptacle to determine if a power
supply is not working.
For additional LED indicator information, see page 39.
Important:
A failed power supply should be replaced as soon as possible to maintain the system’s
power redundancy. For replacement information, contact technical support (see page 43).
Troubleshooting
If a power supply’s AC and DC power indicator LEDs are not illuminated:
Check to be sure the power cord is completely plugged in.
If the AC and DC LEDs remain unilluminated, contact technical support (see page 43).
Caution:
Do not remove a failed power supply until you have the replacement and are ready to
install it, unless directed to do so by technical support. The Epica DGX 144 enclosure is able to
operate normally with a failed RPS; however, a failed RPS may prevent the Epica DGX 144 from
re-booting properly if the system is powered down.
FIG. 21
Power-up splash screen in HyperTerminal
(1:Enclosure) AutoPatch EpicaDG
Ready
Power up splash
screen
Содержание Epica DGX 144
