AMX Epica DGX 144, Инструкция по эксплуатации

Страница: 41 / 107

Installation and Setup
37 Epica DGX 144 Instruction Manual
Attaching Cables
Cable Management Bars
If AMX AutoPatch cable management bars are used, they need to be installed before cables are attached.
Caution: Do not severely bend or kink the SC fiber cable. Irreversible damage can occur. Refer to
the physical limitations (bend radius) specified for the cable by the manufacturer. The bend radius
for AMX SC terminated fiber cables is 2 inches (5 cm).
Input and Output Signal Cables
Before connecting all input and output cables, attach only the first two input and output cables (and any
applicable DGX SC Fiber modules) and execute a test switch (see page 41). When the test switch is
successful, attach the rest of the input and output cables.
Note: The DMS-59 connectors support multiple channels (see FIG. 19). The configuration file and
the internal pathways define each DMS-59 connection as two discrete signal paths for routing.
For information on cabling specific types of connectors, see the specific board chapter in this manual.
FIG. 18
AMX AutoPatch Epica DGX 144 cable management bars
FIG. 19
DMS-59 connectors on a DVI board support multiple I/O channels
Fasten cable management bar
with two screws at top and two
at bottom
Tie cable to cable management
bar far enough below connector
to allow for manufacturer’s
recommended bend radius
The DVI connectors on the DMS-59 breakout cable
are labeled 1 (bottom connector) and 2 (top connector)
and route signals that correspond to the numbering to
the left of the DMS-59 receptacle on the enclosure:
• 1 for the number with the lower numerical value
• 2 for the number with the higher numerical value
DMS-59 connectors (two channels each)