Ametek Drexelbrook Impulse GW Series, Инструкция по установке и эксплуатации

Страница: 69 / 99

Configuration and Calibration
63
4.7 Data Points
The following data points are available in read-only:
Data point Notes
Product level Product level in engineering units selected
System status 0 = SEARCHING FOR SIGNAL, 1 = TRACKING on target, 2 = NEAR
ZONE, 3 = LOST SIGNAL/EMPTY PROBE
Probe length Length from tip of sensor to mounting reference point
Tank height Tank height in engineering units selected
Current highest signal The highest peak signal of product level
Current max signal area The maximum signal area of product level
Product distance
Distance from the bottom of the sensor process connection to
product level
Product volume In volume units selected
Level/distance units 44 = Ft, 45 = Meters, 47 = inches, 48 = CM, 49 = MM
Volume units 40 = Gallons, 41 = Liters, 42 = Imperial gallons, 43 = cubic meters,
46 = Barrels
TDR material type 0 = CUSTOM, 1 = WATER, 2 = OIL
Sensor offset Used if sensor is located above or below the tank height value
Upper dead zone The top portion of the sensor where level can't be measured
Lower dead zone The bottom portion of the sensor where level can't be measured
Damping Time in seconds to dampen out variation in signal due to agitation or
rapid level change
Max volume capacity max volume in engineering units selected
Vessel type 0 = custom vessel, 1 = vertical, 2 = HCYL flat ends, 3 = HCYL
dished ends, 4 = HCYL hemisphere, 5 = spherical
Cable type 0 = SINGLE CABLE, 1 = TWIN CABLE, 2 = SINGLE ROD, 3 = TWIN
ROD, 4 = COAX
Threshold value Preset signal threshold of hydrocarbon (1200) or aqueous loquids
(1500)
Signal area threshold Threshold signal area
Signal being sampled 0 = AMP OUT, 1 = PRE AMP OUT
Date code month 1 thru 12
Datecode day 1 thru 31
Date code year 4 digit year