Ametek Drexelbrook Impulse GW Series, Инструкция по установке и эксплуатации

Страница: 65 / 99

Configuration and Calibration
59
4.5 Configuration Menu (Continued)
Fct. 1.10 Signal Area
(SG AREA)
Sets minimum area for valid signal
level detection. Used to discrimi-
nate a valid level signal vs. an
excursion such as a noise spike.
Preset to 7500 for Hydrocarbon
(Material Type selection “Oil”), or
20000 for Aqueous liquids (Mate-
rial Type selection “Water”).
Editing this function changes
Material Type, Fct 1.05, to “CUS-
TOM”
User editable
value
0 - 32000
Do not
change with-
out Factory
consultation.
Fct 1.05: Material
Type
Fct. 2.00 Volume
(VOLUME)
System configuration for volume
output.
Information entered in Tank
Height, Maximum Capacity, Ves-
sel Type & Sensor Offset are used
to generate a conditioned output.
Use this function to output or
display volume of material in the
vessel. Otherwise skip this func-
tion.
Fct. 2.01 Volume
Units
(V UNITS)
Selects the units of measurement
for all volume based outputs, cal-
culations and configuration entries
Changing units will produce an au-
tomatic conversion of all volume
parameters.
GALLONS
(Default)
M3 (cubic
meters)
LITERS
BBL (bar-
rels)
IMPGAL
(imperial gal-
lons)
Fct. 2.02 Maximum
Capacity
Fct. 2.02 Maximum
Capacity
(MAX CAP)
Enter the volume of the vessel’s
capacity that correlates to the Tank
Height.
User editable
value