American Megatrends Super Voyager LPX, Руководство пользователя

Страница: 65 / 200

Super Voyager LPX ISA Motherboard User's Guide
Step 12 Install Hard Disk
Attach IDE Cable to J4
J4 is a 40-pin dual-inline berg that connects an IDE hard disk drive
to the onboard IDE Controller. Attach the 40-wire IDE ribbon cable
to J4 as shown below.
When you use the onboard IDE controller in conjunction with
another hard drive controller, you must make sure that there are no
conflicts in IRQ and I/O port addresses. The onboard IDE uses
IRQ14 and I/O port addresses 01F0h – 01F7h. If there is a conflict,
the IDE interface can be disabled via Peripheral Setup (see page
164). The J4 pinout is:
Pin Use Pin Use
1 -RESET 2 GND
3 DATA7 4 DATA8
5 DATA6 6 DATA9
7 DATA5 8 DATA10
9 DATA4 10 DATA11
11 DATA3 12 DATA12
13 DATA2 14 DATA13
15 DATA1 16 DATA14
17 DATA0 18 DATA15
19 GND 20 N/C
21 N/C 22 GND
23 -IOW 24 GND
25 -IOR 26 GND
27 IOCHRDY 28 ALE
29 N/C 30 GND
31 INT14 32 -IOCS16
33 HA1 34 N/C
35 HA0 36 HA2
37 -CS0 38 -CS1
39 -IDEACT 40 GND