CY4605 EZ-USB
®
HX2LP™ REFERENCE DESIGN KIT
QUICK START GUIDE
Insert the kit CD/DVD into the CD/DVD
drive of your PC. Review kit contents.
Place jumper on J5 (power status) and J6
(port status) to enable LEDs D1 and D3-D6.
Power LED D1 glows only in self-powered
mode. The green LEDs (D3 and D5) indicate
that the downlink port is enabled. The amber
LEDs (D4 and D6) indicate the port has an
exception condition.
Plug the wall mounted power supply into an
AC power receptacle providing power in the
range 100 V to 240 V, 50 Hz or 60 Hz.
Connect the power supply plug to the hub's
'DC Supply' jack J12.
To connect to the PC, plug the USB A to B
cable into the hub's 'Up Stream' connector
P1. Plug the other end of the cable into one
of the PC's host controller ports. The hub
enumerates as a 'Generic USB Hub'. The hub
is now ready for any low speed, full speed,
or high speed devices to be plugged into the
ports. For the 2-port hub, the board is labeled
PORT1 and PORT 2.
1
2
3
4
