American Magnetics 430, Инструкции по установке, эксплуатации и обслуживанию

Страница: 226 / 254

210 R
EV
9
A
MERICAN
M
AGNETICS
, I
NC
. A
PPENDIX
: R
EMOTE
C
OMPUTER
C
OMMUNICATION WITH THE
M
ODEL
430
C
OMMUNICATION VIA
E
THERNET
1. Connect the Model 430 Programmer RJ-45 Ethernet port either directly to a
host computer or through a computer network on which the host computer
resides:
a. For a host computer on a network, connect a standard Ethernet cable
between the Model 430 and the network.
b. For a direct hardwired connection between the Model 430 and a host
computer, use a “null-modem” or “crossover” Ethernet cable
connected from the Model 430 directly to the host computer.
NOTE
Most modern computers will negotiate the direct connection
cross-over automatically with a standard Ethernet cable.
2. Turn on the Model 430 and press
ENTER
at the “Turn on power supply . . .”
prompt.
3. Press
MENU
to enter the menu system.
4. Use < >/< > to navigate to the
Net Settings
submenu and press
ENTER
.
5. Use < >/< > as necessary to navigate to
Addr Assignment (Present)
.
NOTE
The Addr Assignment (Present) must show “DHCP” as originally
set by AMI.
NOTE
In the following step, the IP Address is the four part number
separated by periods (.), and will change with each Ethernet
connection.
6. Use < >/< > to locate
IP Address (Present)
, similar to that shown below:
7. Make note of the
IP Address (Present)
.
8. Start a terminal emu-
lator program on the
remote computer. As
an example, this pro-
cedure will use the
open-sourced Tera
Term program
8
run-
ning on a Windows
machine. You are
greeted immediately
with the
Tera Term
New Connection
dia-
log.
0.00 A — IP Address (Present)
0.00 Vs
192.168.1.12 (DHCP)