176
R
EV
9
A
MERICAN
M
AGNETICS
, I
NC
.
R
EMOTE
I
NTERFACE
R
EFERENCE
: C
OMMAND
R
EFERENCE
T
RIGGER
F
UNCTIONS
The Model 430 Programmer provides trigger functions which provide a
means of collecting operational data with a minimum of commands and
directing the output to either or both remote interfaces.
D
ESCRIPTION
OF
THE
T
RIGGER
F
UNCTIONS
The Model 430 Programmer defines a
trigger enable register
,
very similar to the enable registers of the status system, which
controls which data is output and the interface to which the data
is presented. The trigger enable register is defined as shown in
the following table:
To enable the trigger functions, the
*ETE <
enable_value
>
command is written with a decimal value corresponding to the
binary-weighted sum of the desired output. Upon receipt of the
*TRG
command, the Model 430 Programmer places the return
data in the appropriate output buffer(s). Data placed in the serial
or Ethernet output buffers is transmitted immediately. Note that
trigger output data may be placed in both the serial
and
the
Ethernet output buffers if desired, but the formatting and output
selections are common to both.
Model 430 Programmer Trigger Function Bit Definitions
Bit
Number
Bit
Name
Decimal
Value
Definition
0
Magnet Voltage
1
Magnet voltage in volts is included in trig-
ger output.
1
Magnet Current
2
Magnet current in amperes is included in
the trigger output.
2
Magnet Field
4
Magnet field in kilogauss or tesla (per the
selected field units) is included in the trig-
ger output.
3
Date and Time
8
The trigger date and time is included in the
trigger output in the form
mm/dd/yyyy hh:mm:ss
4
Supply Current &
Voltage
16
Supply current in amperes and supply volt-
age in volts are included in the trigger out-
put.
5
Formatted Output
32
The trigger output data is formatted.
6
Serial Interface
64
Trigger output data is placed in the serial
interface output buffer and transmitted
immediately.
7
Ethernet Interface
128
Trigger output data is placed in the Ether-
net output buffer.
Содержание 430
