Alutech CU-TR230-868, Инструкция по установке и эксплуатации

Страница: 5 / 130

CONTROL UNITS СU-TR230-868 / СU-TR400-868
3 3
SafETy RULES aNd waRNINGS
within the visibility of doors at a height of not less than 1.5 meters and at a safe distance from
moving elements. Control devices should not be publicly available.
In the case of using radio remote controls, make sure that the installation location of the control
unit provides high-quality radio signal reception (there are no shielding and reflective surfaces,
other sources of radio emission). Otherwise, take measures to ensure the operation of the radio
control (for example, the use of an external antenna).
The electrical network must be equipped with protective earth connection. Make sure that
the earth connection system is correctly designed and connected. The section of the electrical
network to which the product is connected must be equipped with a suitable short circuit
protection device (circuit breaker or other equivalent device) in accordance with the features
of the network and the product.
The electrical cables of the control and safety devices must be laid separately from the mains
voltage cables. Cables should be protected from contact with any rough and sharp surfaces;
use corrugations, pipes and cable entries when laying cables. For electrical connection of drive
system components, use double insulated copper multi-strand cable. The features of used electric
cables (cross-section, number of wires, length, etc.) must correspond to the connection diagram,
device power, laying distance, laying method, and external conditions.
It is necessary to provide protection against crushing, impact, trapping, tightening and other
hazards (EN 12604, EN 12453), it could be achieved by the installation of safety devices; instal-
lation of protective designs; maintaining safe distances and clearances, setting up the product.
The operation of safety devices such as a safety edge or photo line (light curtain) must comply
with the requirements of standards (EN 12978, EN 13849). Ensure safe operation of doors with
automatic drive.
When operating outside the doors visibility zone or when automatic closing of doors is activated
in the settings, photocells (or an equivalent safety device) must be installed.
The product and the entire drive system can be finally put into operation only when it’s confirmed
that the door and the structure its built-in correspond to the requirements and directives of the
existing local rules and regulations.
1.3 dURING OPERaTION
Y
aTTENTION! The product should not be used by children or persons with limited physical,
sensory or mental abilities, as well as persons with insufficient experience and knowledge, who
have not been instructed about the use.
Do not let children play with control devices. Keep remote controls out of the reach of children.
Never grab onto moving doors or moving parts.
Make sure that there are no people, animals, vehicles or objects in the danger area before set-
ting the doors in motion. Observe the movement of doors until they open or close completely.
Passage is allowed when the doors are open, have completely stopped and motionless. Passage
is forbidden when the doors are moving.
Do not stay (stop) in the zone of door movement. Automatic doors may be set in motion at an
unexpected moment!
Inspect the drive system and doors regularly, in particular verify cables, springs, and mounting
hardware for signs of wear, damage, or imbalance. It is forbidden to use a product requiring
repair or adjustment, as a defect in installation and operation can lead to personal injury or
damage to the product.