Alutech CU-TR230-868, Инструкция по установке и эксплуатации

Страница: 31 / 130

CONTROL UNITS СU-TR230-868 / СU-TR400-868
29 29
INSCRIPTION
INSCRIPTION dESCRIPTION
Opening command is activated
Closing command is activated
Stop of movement according to the STOP control command
Control command is activated from input
a
(connector 20)
Control command is activated from input
P
(connector 20) or PARTIALLY OPEN
command of the radio remote control is activated
Input a is activated (connector 20)
Operation of control devices is blocked. The pins of connector 17 (LOCK) are closed
( tab. 2)
Counting pause time until automatic closing
End position error.
For a drive with switches the following may be:
• end position switches are open / input OP.L and input CL.L are activated
(connector 16)
• in the setting P1 – f0 , the value 01 is not set ( tab. 13)
For a drive with encoder the following may be: end positions are not set (section
‘6.1. Setting end positions of doors’, item 3)
*
Built-in security obstacle detection
Safety device / photocells are activated (input PH1 , connector 20)
Safety edge is activated (input SE , connector 20)
PHOTOTEST verification error ( tab. 13, P7 – f3 )
Safety device in the STOP circuit is activated:
• input
S , connector 20
• connector 18 or contacts IN_S and O_S of connector 11
(section ‘5.2. Connection of switches / drive encoder’)
Stop of movement at the end of operating hours (settings
P5
–
f3
,
P5
–
f4
)
Wrong direction of the drive rotation (section ‘6.1. Setting the end position of doors’
item 2 and item 3)
There is no signal from the drive encoder: incorrect or broken encoder connection,
malfunction.
In setting
P1
–
f0
, the value 02 ( tab. 13) for the drive with encoder is not set
Mains voltage is low or there is a unit malfunction (T1A fuse, tab. 20)