Alutech CU-TR230-868, Инструкция по установке и эксплуатации

Страница: 11 / 130

CONTROL UNITS СU-TR230-868 / СU-TR400-868
9 9
SETTINGS
6. SETTINGS
The setting is performed using the buttons, the setting inscription is displayed on the control
panel display 14 ( fig. 8 / 9).
— button to enter the settings menu and exit the menu
— button to enter the setting and confirm the selected value
—
button for stepping into the menu with increasing; also used to control
opening during setting
— button for stepping into the menu with decreasing; also used to control closing
during setting
Y
Table 3 presents a general description of entering the settings menu, selecting and confirming,
exiting the settings menu.
Table 3
1
Press and hold within ~5 s, before entering the settings menu
≥ 5 s
2
After the inscription
P1
appears using or select the
desired menu P0 … P8
3
When the desired menu appears, press
4
Using or select the desired setting from the menu
f0 … f9
5
When the desired menu appears, press
6
The display shows the set value of the operation parameter setting
(
tab. 13). The value will be with a dot. Using or select the
desired setting value for the operation parameter
aTTENTION! For menu P1 , see ‘6.1. Setting the end position of doors’.
For the menu P2 , see ‘6.2. Radio control setting’
7
When the desired setting appears, press .
The inscription will become with a dot, which will mean a change in the
setting value
8
Press the button to exit the settings menu (2–3 times) until a dot
appears on the display.
Y
Automatically exit the settings menu is actuated after 10 minutes
in the standby mode
× 2–3