Alutech CU-TR230-868, Инструкция по установке и эксплуатации

Страница: 13 / 130

CONTROL UNITS СU-TR230-868 / СU-TR400-868
11 11
SETTINGS
1
When the inscription ‘
- -
’ appears on the bottom of display, using
or if necessary set the doors in the position of full
closing
2
Press to confirm the installed position. The inscription ‘ - - ’ will
appear with a dot
3
When the inscription ‘
- -
’ appears on the top of display, using
or if necessary set the doors in the position of full opening
4
Press to confirm the installed position. The inscription ‘
- -
’will
appear with a dot
5
After appearance, the inscription
f3
press twice and exit from
setting menu
× 2
Y
To limit the continuous operation of the drive, adjust the operating time. Settings
P5
–
f3
and
P5
–
f4
( tab. 13).
4. Verify the end position settings.
Use the unit buttons
2
and
4
( fig. 7) to perform
several complete cycles of opening and closing.
Make sure that the inscription of the direction of
movement and the inscription of the end posi-
tions of doors are correct on the display. Make sure
the doors stop at the desired end positions. The
corresponding end position LED is continuously
lighting.
Y
If the position adjustment is required,
repeat item 3 or go to item 5 for drives
with an encoder.
5.
Exact adjustment of the end position of doors (only for drives with encoder):
− in menu
P1
setting
f4
a value for adjusting the opening position is selected ( tab. 13).
− in menu
P1
setting
f5
a value for adjusting the closing position is selected.
LO
P.
L
LC
L.L