© ALLNET GmbH Computersysteme 2015 - Alle Rechte vorbehalten
Irrtum und Änderungen vorbehalten
6
Cautions:
Make sure the power supply voltage is correct before using the camera.
Do not drop the camera or subject it to physical shock.
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean
cloth with a bit of ethanol and wipe it gently. If the camera will not be used
for an extended period of time, put on the lens cap to protect the sensor
from dirt.
Do not aim the camera lens at the strong light such as sun or incandescent
lamp. The strong light can cause fatal damage to the camera.
The sensor may be burned out by a laser beam, so when any laser equipment
is being used, make sure that the surface of the sensor not be exposed to the
laser beam.
Do not place the camera in extremely hot, cold temperatures, dusty or damp
environment, and do not expose it to high electromagnetic radiation.
To avoid heat accumulation, good ventilation is required for a proper
operating environment.
Keep the camera away from water and any liquid.
While shipping, the camera should be packed in its original packing.
Notes:
For the camera supports IR, you are required to pay attention to the following
precautions to prevent IR reflection:
Dust or grease on the dome cover will cause IR reflection. Please do not
remove the dome cover film until the installation is finished. If there is dust
or grease on the dome cover, clean the dome cover with clean soft cloth and
isopropyl alcohol.
Make certain the installation location does not have reflective surfaces of
objects too close to the camera. The IR light from the camera may reflect
back into the lens causing reflection.
The foam ring around the lens must be seated flush against the inner surface
of the bubble to isolate the lens from the IR LEDS. Fasten the dome cover to
camera body so that the foam ring and the dome cover are attached
seamlessly.
