Allmand Maxi-Lit II, Руководство оператора

Страница: 62 / 260

Not for
Reproduction
5-10
MAINTAINING THE LIGHT TOWER TRAILER
• Do not over- or under-tighten the bearing nut.
Wheel bearings should only be tightened by hand
(spin the wheel while tightening). Back off the nut
to insert the cotter pin. The wheel should spin freely,
but without play.
• Pack some grease into the inner hub area and dust
cap and make sure that the dust cap fits tightly.
MAINTAINING THE TRAILER LIGHTS
WARNING
TOWING HAZARD
Never tow the trailer with lights that don’t work.
Lights are a vital safety feature of your trailer and are
required by state law. Keep the lights in proper working
order by doing the following:
• Check the trailer lights and wiring harness for
damage or wear. Repair or replace as needed.
• Make sure that the wiring harness is secured to the
trailer and does not hang down onto the ground.
• Check the tail light housing assemblies for damage
or leaks. Use silicone or rubber sealant to seal the
lens or wiring harness, if needed, or replace the
housing assembly if it can’t be sealed. Electrical
grease will help protect the sockets and prevent
corrosion.
• When replacing bulbs, make sure that you use the
proper bulb.
CLEANING THE TRAILER AND LIGHT
TOWER
Keeping the light tower clean is important to ensure
proper operation. Dirt and dust buildup acts as an
insulator and may cause the engine, generator, and
light assemblies to operate at excessively high
temperatures.
Use the following guidelines to clean your light tower:
• Use caution when using compressed air or water/
steam pressure washers. Do not pressure-clean
electrical components, because it may damage
electrical components.
• Clean the light tower and remove all dust, dirt, or
other foreign material.
• Remove dust, dirt, and debris from the radiator.
• Inspect and clean the cooling air intake and exhaust
louvers of the enclosure. Remove dirt or any
buildup that may restrict the cooling air flow.
• If you use a pressure washer, do not direct the spray
on the following areas:
•
•
•
• Inspect and clean all engine linkages so they
operate properly.