Allmand Maxi-Lit II, Руководство оператора

Страница: 44 / 260

Not for
Reproduction
3-14
USING THE LIGHT TOWER
AUXILIARY AC OUTLET OPERATION
Depending on your model options, the 240VAC single
phase rear outlet panel is equipped with four
240/208VAC outlets and two 120VAC GFCI outlets.
These can be used for powering accessories.
1 Main breaker Turns the whole panel on or off.
2 240/208V
breakers and
outlets
Outlets provide 240V/208V
power. Breakers directly above
turn the outlets on and off.
3 120V GFCI
breakers
Outlets provide 120V power,
protected by GFCI (Ground fault
circuit interrupter). Two reset
buttons are located between the
outlets.
4 Auxiliary
breaker
Turns the 50A outlet on the other
side of the trailer on or off.
The 240VAC outlet is protected by a 30A circuit breaker.
The 120VAC GFCI outlets are each protected by a 20A
push button-type circuit breaker.
The main circuit breaker is a 90A DPST circuit breaker.
If any of the outlet circuit breakers trip:
1
Remove the load from the outlets.
2
Turn off the tower lights (if they are on).
3 Correct the excessive load problem.
4
Wait 10 minutes to let the generator cool down, then
reconnect the load and resume work.
USING OTHER OPTIONAL EQUIPMENT
SAF-T-VISOR
To install the Saf-T-Visor:
1
Turn off the lights and shut off the engine. Allow the
bulbs and fixtures to cool.
2 Lower the light tower to the full down position.
3
Loosen the lens channel screws to allow the removal
of the lens channel.
4 Remove the silicone gasket and lens.
5
Clean the reflector and lens.
6 Install the silicone gasket and lens (replace if
damaged).
7
Place the Saf-T-Visor in the desired location on the
lamp.
a. If the lamp is in a horizontal orientation, the Saf-T-
Visor can be placed on either the top or bottom of
the lamp.
b. If the lamp is in a vertical orientation, the Saf-T-
Visor can be placed on either the left or right side
of the lamp.
8 Once the Saf-T-Visor is placed on the lamp, install the
lens channel and screws.
a. The outer edge of the Saf-T-Visor should be
positioned between the lens channel and the
silicone gasket.
9
Install the J-hooks and screws on the Saf-T-Visor.
a. The J-hooks should be placed around the lens
channel on the back of the lamp, with the screws
on the front of the lamp (near the lens).
MAIN
AUXIILARY
1
2
4
3