Alcatel-Lucent OmniSwitch 6850 Series, Руководство по управлению

Страница: 79 / 292

Logging Into the Switch Using Secure Shell
OmniSwitch 6800/6850/9000 Switch Management Guide December 2007 page 2-17
IP address = 0.0.0.0,
Read-only domains = None,
Read-only families = ,
Read-Write domains = None,
Read-Write families = ,
End-User profile =
Session number = 1
User name = rrlogin1,
Access type = ssh,
Access port = NI,
IP address = 11.233.10.145,
Read-only domains = None,
Read-only families = ,
Read-Write domains = All ,
Read-Write families = ,
End-User profile =
This display shows two sessions currently running on the remote OmniSwitch at IP address
11.133.30.135.
Session number 0 is identified as the console session. Session number 1 indicates the
User name is rrlogin1, the IP address is 11.233.10.145, and the Access type is “ssh” which indicates a
Secure Shell session.
Note. You can use the ssh6 command followed by the IPv6 address or the hostname of the SSHv6 server
to start an SSHv6 session. It is mandatory to specify the name of the particular IPv6 interface, if the
SSHv6 server has been specified using its link-local address. SSHv6 sessions are supported only on
OmniSwitch 6850 or 9000.
Closing a Secure Shell Session
To terminate the Secure Shell session, issue the exit command. The following will display:
-> exit
Connection to 11.133.30.135 closed.
Using the example shown above, this display indicates the Secure Shell session between the two switches
is closed. At this point, the user is logged into the local OmniSwitch at IP address 11.233.10.145.
Note. Establishing and closing the Secure Shellv6 connection is similar to that of the Secure Shell connec-
tion.
Log Into the Switch with Secure Shell FTP
To open a Secure Shell FTP session from a local OmniSwitch to a remote device, issue the sftp command
and identify the IP address or hostname for the device you are connecting to.
You can use the sftp6 command to start an Secure Shell FTPv6 session followed by the relevant IPv6
address or hostname, over an IPv6 environment.
The following example describes how a Secure Shell interface is established from the local OmniSwitch
to IP address
10.222.30.125
:
1 Log on to the OmniSwitch and issue the sftp CLI command. The command syntax requires you to