Alcatel-Lucent OmniSwitch 6850 Series, Руководство по управлению

Страница: 179 / 292

Managing Switch User Accounts Overview of User Accounts
OmniSwitch 6800/6850/9000 Switch Management Guide December 2007 page 7-7
Quick Steps for Creating Customer Login User Accounts
1 Set up a user profile through the end-user profile command. For example, configure a profile called
Profile1 that specifies read-write access to the physical and basic-ip-routing command areas:
-> end-user profile Profile1 read-write physical basic-ip-routing
2 Specify ports to which the profile will allow access. In this example, Profile1 will be configured with
access to ports on slot 1 and slot 2.
-> end-user profile Profile1 port-list 1/1-2 1/4-5 2/1-8
3 Specify VLANs or VLAN ranges to which the profile will allow access. In this example, Profile1 will
be configured with access to VLANs 3 through 8.
-> end-user profile Profile1 vlan-range 3-8
Note. Optional . To verify the end-user profile, enter the show end-user profile command. The display is
similar to the following:
End user profile : Profile1
Area accessible with read and write rights :
physical,
basic ip routing,
Slot : 1, ports allowed : 1-2, 4-5
Slot : 2, ports allowed : 1-8
Vlan Id :
3-8
For more information about the show end-user profile command, see the OmniSwitch CLI Reference
Guide .
4 Associate the profile with a user account. Enter the user command with the relevant username and
password and specify Profile1 . In this example, the user name is Customer1 and the password is
my_passwd :
-> user Customer1 password my_passwd end-user profile Profile1
For more information about creating a user and setting up a password, see “Creating a User” on page 7-10 .
For information about creating end-user profiles, see “Setting Up End-User Profiles” on page 7-20 .
Note. Optional . To verify the user account, enter the show user command. The display is similar to the
following:
User name = Customer1
END user profile = Profile1
SNMP authentication = NONE, Snmp encryption = NONE
User name = default
END user profile Profile5
Snmp not allowed
For more information about the show user command, see the OmniSwitch CLI Reference Guide .