Alcatel-Lucent OmniSwitch 6850 Series, Руководство по управлению

Страница: 161 / 292

Working With Configuration Files Tutorial for Creating a Configuration File
OmniSwitch 6800/6850/9000 Switch Management Guide December 2007 page 6-3
4 Use the show configuration status command to verify that the dhcp_relay.txt configuration file was
applied to the switch. The display is similar to the one shown here:
-> show configuration status
File configuration <dhcp_relay.txt>: completed with no errors
File configuration: none scheduled
Running configuration and saved configuration are different
Note. If the configuration file applied with the configuration apply command results in no changes to the
saved configuration, the message will state that the running configuration and saved configuration are
identical . To synchronize the running configuration and the saved configuration, use the write memory
command.
For more information about these displays, refer to the OmniSwitch CLI Reference Guide .
5 Use a the show ip helper command to verify that the DHCP Relay parameters defined in the configu-
ration files were actually implemented on the switch. The display is similar to the one shown here:
-> show ip helper
Forward Delay (seconds) = 15
Max number of hops = 3
Forwarding option
= standard
Forwarding Address:
128.251.16.52
These results confirm that the commands specified in the file dhcp_relay.txt configuration file were
successfully applied to the switch.