Air Lift LoadLifter 7500 XL, Руководство по установке

Страница: 9 / 28

MN-1033
7
fig. D.7
fig. D.8
RETAINING CLIP L-BRACKET INSTALLATION ON BRACE
1 . In order to reattach the previously removed emissions line, attach the provided
L-bracket (K) to the back frame brace using the 1/4"-20 x 1" bolt (L), flat washers (R)
and 1/4"-20 nylon lock nut (T) supplied (Fig . D .5) . Placing this L-bracket depends on
where the line holder is on the wiring or the emissions line that was previously pulled
from the frame . Set the driver’s (left) side frame brace (E) against the frame and
insert the 8mm-1 .25 x 25mm hex-cap screw (P) with an M8 flat washer (X) through
the brace and into the hole in the side of the frame from which the line holder was
removed (Fig . D .8) . This will hold the line in place . Note which side the line holder
is in, in respect to the back leg of the brace . Is it forward or behind the back leg of
the brace? Where the line holder lines up is the side where the L-bracket is to be
installed (Figs . D .7 & D .8) .
2 . Pull the brace back out and attach the L-bracket onto the brace with the hardware
noted above, in the proper location previously found (Figs . D .9 & D .10) . Make sure
the L-bracket faces up and tighten securely .
Image shows
lines clear on
the frame,
opening it up
for the brace
installation .
Brace being
temporarily held
in place by the M8
bolt and washer .
L-bracket is shown
in location already .
Note: The side
the line holder is
on depends on
the location of the
factory retaining
clip .
fig. D.9 fig. D.10
LoadLifter 7500 XL
7
No matter what side the L-bracket is
on, make sure it is installed so the flat
side points up when tightening . Attach the L-bracket to the brace in
the position previously found using
the hardware specified .