Air Lift LoadLifter 7500 XL, Руководство по установке

Страница: 19 / 28

MN-1033
17
3 . Set the passenger's (right) side assembly into position on the jounce bumper strike
plate the same way the left side was positioned (Fig . D .38) . Note: the long carriage
bolt goes outside of the hard brake line on the passenger's (right) side .
4 . Make sure the thick spacer (H) is parallel to the frame and bracket (Fig . D .39) . Finish
raising the axle or lowering the frame until the spacer contacts the frame on both
sides .
5 . Install the 3/8"-16 serrated flange lock nut (S) on the 3/8"-16 X 2" carriage bolt (M)
that went through the existing jounce bumper hole and tighten securely on both sides
(Fig . D .40) .
BE SURE NOT TO PINCH THE PREVIOUSLY MOVED WIRING OR LINES INSIDE THE
LEFT FRAME RAIL .
fig. D.38
fig. D.39
fig. D.40
Make sure the
spacer (H) is
parallel to both the
frame and upper
bracket . Raise axle
or lower frame until
the spacer touches
the frame on both
sides .
Install the 3/8"-16
serrated flange lock nut
(S) onto the 3/8"-16 x 2"
carriage bolt (M) that goes
through the flange on the
frame and tighten .
The long carriage
bolt goes on the
outside (backside)
of the hard brake/
ABS line on the
passenger's (right)
side .
H
S
M
LoadLifter 7500 XL
17
CAUTION