Air Lift LoadLifter 7500 XL, Руководство по установке

Страница: 23 / 28

MN-1033
21
6 . Tighten the axle clamp bar hardware evenly until it touches the axle (see note
below) . Torque the axle clamp bar bolts to 16 lb .-ft . (22Nm) (Fig . D .50) . Repeat for
the opposite side . Trim the 3/8"-16 x 10" carriage bolts below the nylon lock nuts if
necessary .
DO NOT PINCH THE HARD BRAKE LINE ON THE PASSENGER'S (RIGHT) SIDE WHILE
TIGHTENING .
7 . Torque the leaf spring U-bolt hardware to 10 lb .-ft . (14Nm) . Repeat for the opposite
side . Once tight, the upper and lower brackets will not be parallel and may look like
they are out of alignment . This condition will be OK because of the way the lower
bracket and upper bracket mounts are designed . Some variance from one unit to
another is considered normal .
8 . Raise the axle up all the way (if not already done so) and remove the safety stands or
equivalent used during the installation .
It may be necessary
on some models to
not tighten the axle
clamp bar evenly
on the passenger’s
(right) side so that
the clamp bar will
clear the hard brake
line .
fig. D.51
9 . Tie together the soft and hard brake lines that are close to the lower air spring roll
plate on the driver's (left) side with the large zip tie (VV) (Fig . D .51) .
fig. D.50
LoadLifter 7500 XL
21
CAUTION