Air Lift LoadLifter 7500 XL, Руководство по установке

Страница: 10 / 28

MN-1033
8
DRIVER’S (LEFT) SIDE BRACE INSTALLATION
1 . Set the left upper brace (E) into the driver’s side frame rail . The brace has a small hole
that will line up with an existing hole in the frame . Insert the M8-1 .25 x 25mm hex-
cap screw (P) with an M8 flat washer (X) through the brace and frame (Figs . D .11 &
D .12) and cap with a M8 flat washer (X) and M8-1 .25 nylon lock nut (Y) . Leave loose
at this time .
BE SURE NOT TO PINCH THE PREVIOUSLY MOVED WIRING OR LINES INSIDE THE
LEFT FRAME RAIL .
2 . If the truck has no fifth-wheel hitch or if it has the
standard equipment Reese fifth-
wheel hitch that was purchased on the truck from Ford, in the frame there is a slot
that is forward of the 8mm bolt just installed, insert the 1/2"-13 x 1 1/4" hex-cap
screw (Q) and 1/2" flat washer (W) through the brace and frame (from the inside out) .
Cap with a 1/2" flat washer (W) and a 1/2"-13 serrated flange lock nut (Z) (Figs . D .11,
D .13 & D .14) . Do not tighten at this time .
OR
fig. D.12
fig. D.13
Attach the
bracket to the
frame using the
8mm hardware
noted .
Driver’s (left) side
brace shown
with supplied
hardware in
place . Existing
fifth-wheel
hardware which
may have been
removed may
look different .
fig. D.11
LoadLifter 7500 XL
8
CAUTION