MN-1033
18
6 . Cap the 3/8"-16 x 1 1/4" carriage bolts (O) with 3/8" flat washers (V) and 3/8"-16
nylon lock nuts (U) on both sides and torque to 15 lb .-ft . (20Nm) (Fig . D .41) .
7 . With the spacers (H) on the upper brackets tight to the bottom of the frame and the
braces tight to the upper brackets, tighten the 8mm (driver’s [left] side only) and 1/2"
or 3/4" hardware previously installed, that hold the braces to the frame (Fig . D .42) .
Tighten both sides .
If possible, use a thin socket. It helps to pull back the driver's (left) side mounting hardware
(Q or CC) as far back in the slot as possible while tightening.
8 . Once the driver’s (left) side 1/2" or 3/4" hardware has been tightened, push the wiring
harness connector – which was removed in the Getting Started section – back into
the gas/DEF tank mounting hole . If the connector broke during disassembly, zip tie it
to the bracket (Figs . D .4 & D .5) .
9 . If equipped with the emissions line previously loosened from the frame, insert the line
holder post into the L-bracket (K) attached to the back leg of the upper left brace (E)
(Fig . D .43) . It may be necessary to move the line holder post forward or back on the
lines to line up correctly with the L-bracket hole . Reattach any line holders removed
forward or behind the axle, if possible, that were removed to aid in positioning the
upper bracket .
fig. D.42
fig. D.43
fig. D.41
Cap the 3/8"-16
x 1 1/4" carriage
bolts (O) with 3/8"
flat washers (V)
and 3/8"-16 nylon
lock nuts (U), then
torque to 15 lb .-ft .
(20Nm) . Repeat
for the other side .
Tighten the M8
hardware and the
1/2" (or 3/4" if
from the fifth-wheel
hitch hardware) and
tighten securely .
Repeat for the
hardware on the
opposite side .
U
V
O
Insert the line
holder previously
removed into the
L-bracket installed
on the upper
brace as shown .
NOTE
LoadLifter 7500
XL
18
Содержание LoadLifter 7500 XL
Страница 2: ......
